21st Century Arbor Press
Gear Review by Germán A. Salazar, Contributing Editor
Reloading at the range with an arbor press and Wilson dies is my preferred method of load development. I just received a new arbor press from 21st Century Shooting, and am very favorably impressed by it.
An arbor press’ basic function is simple enough: exert sufficient downward pressure on the die to either size the case neck or seat the bullet depending on which die is in use. It isn’t a mechanically challenging func-tion. So why do we use an arbor press and what should be look for in one? Consistent operation, sensitive feel, quality of design and machining are the hallmarks of a good arbor press and this 21st Century unit earns good marks in all areas.
For my initial session with the press, I seated 72 bullets in .30-06 cases, another 70 in .308 cases and neck sized a handful of cases (just for evaluation since I prefer to full-length size). The design of the actuating arm, which angles slightly away from the press was very convenient, allowing me to operate it with less jostling of the press because my fingers weren’t bumping into the press head as they sometimes do with my previous press that has the handle parallel to the press head. That’s a nice touch and shows the press was designed by someone who has used these things.
The press uses a relatively light return spring which materially aids the feel of seating pressure. I prefer this to a heavier return spring which would reduce the feel that I really look for in an arbor press. For someone who uses very heavy neck tension this might not be a big concern, but because I usually use 0.001″ to 0.002″ neck tension, the ability to detect small levels of variance in seating pressure is important to me.
High Quality Machining and Parts Finishing
Every part of the 21st Century press reflects careful thought and skilled machining. The knurled wheel for adjusting the height of the press head is a distinct improvement over the plastic hardware store knobs seen on many presses.
The aluminum press head itself is nicely anodized, the steel base well blued and the shaft nicely polished. Even the decapping base (photo at left) reflects careful design as well as precise machining. Overall, the press gives a look and feel of quality and is a welcome addition to my range reloading setup.
21st Century Shooting Inc., a site advertiser, supplied an Arbor Press for testing and evaluation.
Editors’ Note: The designer of the 21st Century Arbor press has decades of tool-making experience, and he has designed tools for many “big-name” companies. 21st Century stands behind the product with a lifetime warranty for the original purchaser. The Arbor Press is currently offered in two different versions, either with 3″ x 4″ baseplate for $85.99, or with 4″ x 5″ baseplate for $89.99.
21st Century Shooting