Articles tagged with "Neck-turning"

• 

  .300 Lapua Magnum Cartridge Guide

  Background -- The .300 Lapua Magnum, aka 30-338 LapuaFor long-range shooters the marriage of the ultra-strong .338 Lapua Magnum case...
  https://www.accurateshooter.com/cartridge-guides/300-lapua-magnum-cartridge-guide/Read More

• 

  Neck-Turning Lathe from 21st Century

  21st Century Shooting has just released a new Neck-Turning Lathe system. This is a great product that may revolutionize the...
  https://www.accurateshooter.com/gear-reviews/neck-turning-lathe-from-21st-century/Read More

• 

  Speedy’s 6PPC — Art of Accuracy

  When Texas gunsmith Speedy Gonzalez set out to build the "ultimate PPC" for his own use, he wanted it to...
  https://www.accurateshooter.com/guns-of-week/gunweek041/Read More

• 

  Complete Precision Case Prep

  Copyright © 2003 Precision Shooting Magazine. Reprinted by permission, all rights reserved. Preparing Cases for Long-Range Accuracy by Jacob Gottfredson I have always...
  https://www.accurateshooter.com/technical-articles/reloading/complete-precision-case-prep/Read More

• 

  Neck-Turning with Lathe or Mill

  [as_banner] EDITOR'S NOTE: The most accurate rifles on earth are short-range Benchrest guns, primarily chambered in 6 PPC. Almost without exception...
  https://www.accurateshooter.com/technical-articles/neck-turning-with-lathe/Read More

• 

  Neck-Turning Basics

  This article is an introduction to neck turning for High Power shooting. The reasons we might choose to turn necks...
  https://www.accurateshooter.com/technical-articles/neck-turning-basics/Read More

• 

  Neck Tension — Not Just Bushing Size

  In our Shooters' Forum a reader recently asked: "How much neck tension should I use?" This prompted a Forum discussion...
  https://www.accurateshooter.com/technical-articles/reloading/neck-tension-not-just-bushing-size/Read More

• 

  Neck-Turning Tool Cutting Tips

  When neck-turning cases, it's a good idea to extend the cut slightly below the neck-shoulder junction. This helps keep neck...
  https://www.accurateshooter.com/technical-articles/neck-turning-tool-cutting-tips/Read More

• 

  Lapua 6mmBR Brass Report

  Robert Whitley sampled a recent lot of Lapua 6mmBR brass and found that the neck-walls are marginally thinner, resulting in...
  https://www.accurateshooter.com/technical-articles/lapua-6mmbr-brass-report/Read More

• 

  K&M Neck-Turner Holder by Pendergraft

  by German Salazar, RiflemansJournal.com Neck turning isn't a once-in-a-while operation at my reloading bench. I shoot a lot, go through a...
  https://www.accurateshooter.com/gear-reviews/km-neck-turner-holder-by-pendergraft/Read More